Estás en 3DFinder
Buscamos en Thingiverse, MakerWorld y Printables al mismo tiempo para darte lo mejor de cada una.
Descripción
My first design to upload, inspired by the #FilamentChallenge , Intend to put this to use on my new delta printer but I'm sure it can be used in many applications with its simple mounting points(bolt spacing also allows attachment to the side of my CTC Dual using the top frame screws, may be the same for other Replicator Clones?)
"Finger Grip" is intended to be used with an M8x1.25 screw in place of the printed screw.
Instrucciones
Printed main body at 0.2mm due to internal threads, Capture Plate at 0.3mm and the screw at 0.1mm.
Thread Size in the main body is M8x1.25 if you need to run a tap down it or substitute the printed screw for another.
