The fake knife switch actually mounts OVER THE EXISTING PLATE, which makes this design safer than the previous one, because we all know that PLA does not meet the eletrical code safety standards.

IGOR! Raise the switch! Muhahahahaaa It's aliiiiiiiiiiiiiive!!!!!!!!!!

Thanks goes to Jeff (aka LoboCNC), for it's original design: http://www.thingiverse.com/thing:649284.

Either print the plate or the plain plate, if you don't want the wood lines. This will need extreme bridging, give it a try, it's a nice challenge. After printing just cut out the switch rectangular hole and punch both screw holes with a drill bit.

The plate actually mounts OVER THE EXISTING PLATE, which makes this design safer than the previous one, because we all know that PLA does not meet the eletrical code safety standards.

Gently squeeze the handle into the plate.

The rocker will snug fit the actual switch, it may require a little dab of glue just to make sure it stays there.

The knob can be printed with Flexible plastic, for extra coolness, but if you print it with hard plastic, scale it up a bit.

Also, don't forget to yell "IGOR, RRRAISE THA SWITCH!!" every time you turn the light on.... :)

Just added the files for double, triple and even quadruple gang switches. Use the narrow handle for these. And also be prepared for insane bridging on the quad...