Basic spool to keep your assorted lengths of wires.

Update:

• separate parts
• slightly thicker parts
• little hole in the tube to hold the wire
• small gap in the spool to catch the end
• added a spool axle holder, just cut a 5/8th PVC electrical tube to length. I’ve added a hole so you can screw it down if the tolerances don’t match up with your printer. Also there are a few mounting screws for screwing to a wall or baseplate (screw go on the outside, bolts on the inside)

Because of the tolerances of the print, assembly may need a little sanding before it fits tightly.

The v3 file fixes an error where not all objects where aligned vertically.

The spool consists of three parts that lock together. Print flat like in the STL.