This is a mini-makerbot for your cube farm: http://www.thingiverse.com/thing:8012

It just wouldn't be the same without your epic 3D Printer, now would it?

ADDED: Makerbot_V2.stl - Just a few tweaks. Makerbot_WKeyring.stl - Added a small hole in the top corner, so it can be put on a keychain. Untested currently.

ADDED 6/17/2011: Makerbot_v3.stl - Made outside columns thicker. Moved keyring hole to bottom, for a bigger and stronger keyring.

ADDED 6/18/2011: Makerbot_v4.stl - Added Fan holes. Very slightly thicker nozzle. FileCabinet.stl - Simple 3 drawer file cabinet, by request.

ADDED 6/19/2011: Makerbot_v5.stl - Added small hole in top for mini-filament. (extrude a little bit of plastic, cut off, glue in mini-hole on top) -Picture of white v5 with green mini-filament added.

ADDED 6/21/2011: Makerbot_v6.stl - Deeper hole for mini-filament. Mini-USB detail added. Base_(3,4,6).stl - Base for legs Leg.stl - Legs

-Base and Legs added, make your mini-Makerbot into a mini robot, ready to replicate and conquer!* Or use it to display something else.

*Note that this will not actually happen...Hopefully.

Print. Reversal is greatly suggested. Because it is awesome.

(Also Cool -> Slowdown would be a good idea (I used 20sec for min time))

ADDED: Found it prints a bit better when build platform temp is lower than normal, around ~100 *C.