For some reason this print seems aesthetically pleasing - so I'm told.

Designed in MOI.
Made in Bilby3D PLA on an Ultimaker 1

Note that the stl file was scaled up by a factor of 2.

Without scaling up I've found it difficult to print successfully in PLA (on the Ultimaker) - I have printed without scaling up in ABS on a Robox.

Even scaled up it's a bit of a challenge. See instructions for recommendations.

I recommend:
a) for 2x size
220C
0.2 layer height
1.2mm wall thickness
20% fill
Brim
Support touching baseplate. This is essential.
Support throughout is an alternative though can be difficult to remove.
Moderately slow print speed.
b) for 1x size
220C
100% fill
Brim
Support touching baseplate.
Really slow printing speed.