You can use this tool for three things:

1. Use the sharp edge to help remove projects from the print bed
2. Use the underside (rough) of the scraper to clean the print bed after a print to get any stubborn filament strands off.
3. Use the rounded corner to apply and flatten new tape to the print bed.
   You can also hang it on something with the hole.

Note: The size of the scraper is 1" wide, and ~ 2.22" long. Scale it up if you wish to make it bigger.

For this project, I used a MakerGear M2 with 1.75mm Natural Color
PLA filament. I suggest using 50% or higher for the infill setting.

Settings:
0.20mm Layer height
50% Infill
Raft enabled
100% Cooling fan speed

For the support, I flipped the Scraper on its side to get rid of the
need for support material.