Estás en 3DFinder
Buscamos en Thingiverse, MakerWorld y Printables al mismo tiempo para darte lo mejor de cada una.
Descripción
VertiBOT is an educational project to investigate and understand sensor fusion using kalman and complementary filter algorithm and PID control in an unstable system.
VertiBOT is an inverted pendulum platform that remains balanced by means of two tiny motors, located in the bottom of the structure. The battery is attached in the top of the main body, while the electronics board is located near the rotation axis.
The feedback signal is provided by an IMU 6Dof composed by an accelerometer and a gyro. One ATmega 328 microcontroller execute the main loop every 10 milliseconds. A wireless communication over bluetooth is used to tune and check the signal response in a Graphical User Interface software.
Video: http://youtu.be/A5KtT4GVpx8
Useful info, schematic and code available: http://wp.me/p22sj0-fT
Instrucciones
- Microcontroller ATmega 328 16MHz (Arduino nano).
- IMU 6Dof: accelerometer y gyroscope.ADXL345/ ITG3200
- Motor Driver Pololu Qik2sv1.
- Bluetooth modem for wireless communication.
- Potentiometer for PID tuning parameters
- Buttons for different tasks: algorithm change, calibration offsets ..
- Voltage regulator (MCP1700) and logic converter .
- Pololu MicroMetal Motors (50:1)
- Pololu Wheels 90x10mm
