Suitabe for all Tablet PCs not thicker than 15mm

Designed for ExoPC Slate, fits also for WeTab

The Stand is adjustable in its angle. 5 Steps between 80° and 30°

On the Pictures is only one Stand visible. Currently I have only one finally assembled, because I lost some parts between printing and assembling.

If you print the File once, than you get enough Parts for two of them. One Stand only is to instable for a tabletcomputer.

Oh, and there was some HEAVY warping during print. I managed to assemble the Part, but it doesnt look very fine. I will print that Thing again, as soon as we have a HPB in c-base

Drill with Raft from printing still on, this helps getting the holes vertical..

Re-Drill the holes with 4mm Drill.

Sand the Baseplate off, Clean up the parts with knife.

Assemble with threaded Rod and Nuts.