This is a simple cable clip that allows you to quickly snap a wire into a designated place so that you can find it again later. I use it to stop my charger wires from falling in between my desks.
.
Inspired by this thing but I thought that it looked like it wouldn't work and seemed to waste a lot of material considering what it did.
http://www.thingiverse.com/thing:70549

SCALE the model based on what size wire you have. The model is set for a 3mm diameter wire so use the calculation: diameter of wire / 0.03. This will give you a required scale in percentage.
.
PRINT one or two or three of the clips
.
CLEAN surfaces with alcohol wipes or methylated spirits or mineral turpentine to help the tape stay stuck for longer
.
STICK the clip down with double-sided tape
.
I AM NOT RESPONSIBLE FOR ANY SURFACES RUINED WHEN CLEANING