-DailyEarrings & Prologue: www.wap.cc / thingiverse.com/thing:7120

Because I made the features slightly over-proportional it looks a bit odd, but it was neccesary to show on the tiny print.

It is a bit hard to print at this scale, as the support is either hard to clean or it will affect the quality (see Instructions below).

I included a second SKP file with flat legs, which I have not printed yet. It should solve some issues...

Nothing coloring can't fix though.

Print facing up, as cleaning support when standing is nearly impossible. You could print it on the back, but this will probably ruin the texture.

I included a second SKP file where I made the legs flat, which should make it easier to print "standing".