Infinite Hat Rack This was inspired by the infinite over the door hat rack at www.thingiverse.com/thing:2515938

I needed a hat rack that included extension pieces so I could space out the hooks farther for my broad brimmed hats. This model includes an over-the-door top (gap sized for my 37mm door); a hat hook; and an extension piece. Attach pieces by lining up the edges of the small hooks at the top and bottom of each piece, one next to the other, and sliding together.

Scaling: All pieces need the same x/y scaling to attach correctly. Width (z-axis) can be independent.

• Top: scale in the x direction to adjust the gap for your door. Avoid scaling the z-axis too much smaller because the walls are intentionally thin (only 1.5mm) to avoid damaging the door frame, which makes it kind of flimsy.
• Hook: I chose 30mm z-axis width because this was a good size to avoid denting my hats. Make wider or smaller as needed to fit your hats.
• Ext: the default model is 30mm wide to match the Top & Hook pieces but this could be sized smaller to save printing time & material (see example picture--1 ext piece is 30mm, and the other 2 are approx 30%).

Printed without supports or raft.

Models made with FreeCAD and Ultimaker Cura.