General purpose box

Rugged box for storing anything you need

Top and bottom files are the box itself
Pin is for the hinge. You will need 4 of these. Clean holes with 5mm drill before for easier mount. they are split in a half for better printability and strenght.
Latch is better if printed around 101 or 102% bigger for smooth sliding without need of sanding. mount is simple slide in place on top shell when open.
Optinoal seal is to be printed in TPU 2 walls 20% infill.
Shelf is optional also for small stuff organization.
Handle is optional also depending on your needs. To be screwed in place.

Internal dimension is: 18cm width x 16cm lenghth x 16cm depth supports use is minimal only needed on latch rails that can be on the wall itself and do not need to go untill printer table

See in my profile many others usefull boxes

Descrição