##Introducing the Valve Steam Controller Charging Stand!

###Introduction I was lucky enough to get an order in during the first wave of Steam Controllers earlier this week, and now that I have my hands on it I thought it would be a good idea to have an organised spot on my desk to keep it. So after sitting down for an afternoon and making a couple quick prototypes, I have now completed a 'V1' of a controller stand!

###Description The stand is fairly simple, you can print it off, remove the supports, and start using it! The design in the photos was printed with the Bambu Matte Black (Charcoal) PLA. Print it off, and let me know what you think!

###Features

• A stand for your Steam Controller & Puck (duh)
• Cable storage vacancy (inside the bottom, covered by the removable lid)
• Cable passthrough channel on left, right, and back sides.
• USB-C pass-through hole to power the puck.
• Lip around the puck cradle, if you pull up you can remove the controller with the puck for tethered play. Or, pulling towards yourself will let you keep the puck in the stand for wireless sessions! (Check out the gifs in the media above)

###Disclaimers & Acknowledgements I must give a huge thank you and acknowledgement to Valve for releasing the STL and STP versions of the controller and puck, as I referenced those for the measurements for this design. I would not have been able to make this as accurate with just a pair of calipers (:P). Those designs are available at https://gitlab.steamos.cloud/SteamHardware/SteamController

You may sell this design if you wish, however you must give attribution to this design page, or my profile. If you like this design, consider supporting me here: [https://ko-fi.com/astraxiom](https://ko-fi.com/astraxiom)

Thank you for reading this far, and I hope you enjoy!