Hello all you 3D wizards out there. Here is your opportunity to defy gravity. Can your audience balance this Skyhook on the tip of their finger? Well let them try!!! Then with the powers of your magical belt you defy gravity. Drape belt over Skyhook while inserting it into the slot as shown in the picture. Shazam, the Skyhook will balance on the tip of your finger. What fun when you amaze your audience of your powers.

How does it work? Think of it like a rotating wheel where the belt is creating rotational force "torque" extending out to the tip of the Skyhook and the center of the wheel is the bottom of the Skyhook slot.

Thanks for looking.

The print was designed on Tinkercad and should print in less that an hour. Using approximately .2mm layer thickness I set the slicer for 3 layers on the bottom and 5 solid layers on top so the 1mm tall letters are solid. I also used 25% fill.