Skeleton Spool Refill System

Fast printing, multi-hub refill system!

Compatible with Bambu Lab & equivalent refill spools.
Two diameters - 175mm and 200mm
Four hubs for use with internal and external AMSes, arms/hangers, and M8 rod (old skool)
Print fully featured refill spools better, faster, cheaper.
Outside diameter 200mm or 175mm, width 67mm, with a hub diameter of 55mm.
The rims with the SKIRTs are stiffer and preferable to the plain ones.

NOTES

Requires six M4x16mm cap-screws and nuts.
Uses AA batteries for ballast to stop near-empty spools jumping in AMSes.
The locator superglues into one of the rims (print it in a bright color).
Do not store in vacuum bag because it will probably deform.
If using a filament dryer, print spool from a material with a higher temperature rating than the refill.

For a more conventional refill spool, visit: [https://www.thingiverse.com/thing:6896875](https://www.thingiverse.com/thing:6896875)

Check out more printer accessories from Department_Nine!

Bambu and Bambu Lab are the trademarks or registered trademarks of their respective holders. No relationship exists or is implied between Department 9 or any other company.

Descrição