Open front mini buildable house! I made this so my daughter had a home for her small dolls. I plan to update models to add far more detail in the future. No furniture is included.

Everything is included in Buildable_Tiny_House.zip file. These will take a WHILE to print. The dimensions of the house fully assembled are 200x600x127mm, so not exactly "tiny".

Assembly

1. Connect bases together using dowel rods. These may be a tight fit, as intended.
2. Connect walls together using small beveled rectangles(can not connect center two walls in this way). May be tight fit.
3. Populate bases with small beveled rectangles along the edges. There should be 8 small slits for the center two walls unpopulated as the rectangles will not fit in them.
4. Align the walls to the beveled rectangles in the bases and press them DOWN into place. May be a tight fit.
5. Place the two center walls into the bases.
6. Place the 6 long rectangular pieces into the slots of the same size on top of the walls. NOTE 2 pieces are 200mm. These go to Front/Rear center walls. 2 pieces are 198mm. These go to Left/Right Rear. 2 pieces are 196mm. These go to Left/Right Front.
7. Align the guides on the bottom of the roof piece to the slot in the walls. Roof pieces should just sit right into their dedicated slots. DONE

Print Material: PLA Support: Yes Infill: 15%