Tired of looking for a spot to set your drill? The Quick Disconnect Drill Holder might be the solution for you. The holster exists in two versions: latching and non-latching. The latching version has a lever that can be engaged to lock the drill in the holster, even in an upward force is applied to the drill. The latch in automatically disengaged when the drill is inserted and must be manually engaged. The latch is engaged by pushing the the lever down, it is disengaged by pulling it up. Currently This item only officially supports Milwaukee drills and impacts. Other brands may be compatible, but have not been tested. This model is still a work in progress and further improvements will be coming. Use at your own risk.

Print Settings:

• Drill Pin >* Infill: 100% >* Supports: No >* Material: PLA

• Drill Holster: >* Infill: 15% >* Supports: Tree only from build-plate >* Material: PLA

• Latch: >* Infill: 15% >* Supports: No >* Material: PLA

Instructions:

• Print the drill pin and drill holster
• Print the Belt Clip
• Attach belt clip to drill holster using 4 6-32 screws
• Attach drill pin to drill using a 6-32 screw
• Additional instructions for Latching Holster: >* Print Latch >* Choose side to install latch, place latch with handle facing down on the outside of the holster > * Align latch hole with holster hole >* Attach Latch with 6-32 screw, be sure to not overtighten screw to allow smooth movement of the latch

Additional Materials:

• 5x (6x if using the Latching Holster) 6-32 Screws