L-shaped shelf bracket for 200mm boards Features:

• Wall mount holes: Ø 4.5mm (for screws/anchors)
• Board fixing holes: Ø 3.5mm (for securing the shelf)

Reinforced design: 100% infill around wall mount holes (for maximum strength) 30% infill elsewhere (adjustable for heavier loads if needed)

Notes: Increase infill for higher load capacity. Test with your specific wall anchors/screws before full load. Print with the wall-mount side facing down on the build plate. This way, only the wall-mount holes require supports (minimal support needed).

[UPDATE PLANNED] V2 will include 2 wall-mount holes and 2 shelf-securing holes. Stay tuned!