This is a remix of the Lithophane Table Lamp (Truncated Octahedron) for the base. This allows the top to be rotatable so you can see the facets all round.

Things needed:

• 5mm metal balls (qty: 5)

Assembly:

1. Start with Bottom Base.
2. Feed LED cable through the Bottom Base, tuck the wire under groove of bottom base.
3. Drop in Ball Bearing Retainer in groove of bottom base.
4. Drop the 5 metal balls into the retainer.
5. Place Top Base over the Bottom Base, such that retainer sits in groove of Top Base.
6. Place Cap on top, slide alignment tabs into Bottom Base. Use existing screw to fasten LED from original assembly through the center.
7. Place Original Lamp on top and test rotation. It should only seat aligned with Top Base. It is no longer a snug fit. For snug fit, use Top Base (Snug Fit)

Note: if it does not rotate smoothly, loosen the screw.