This is my first remix. Actually my first time sharing anything I've done.

One of my kiddos asked if I could print the Minecraft Lantern by lemonfoxmere. Difficult to turn down a request like that. After looking at it, I decided I wanted to change it up a bit by using a WS2812 Ring LED array driven by a MagWLED board so they could control the array from the WLED phone app without needing to create an account anywhere. This also let me have just a USB C connector for power instead of using mains voltage.

I modified the Base Plate making it a bit deeper to accommodate the MagWLED on standoffs and also a bit more room for the USB C connector, and removed the cable clamp/strain reliefs. The Base Lid was also slightly modified to remove the power cable tab thingy. Created one new part that the WS2812 mounts to in the Cap. I also ended up slicing the little raised edges on the Panes off because my trusty Ender 3 V3 SE just couldn't quite handle them so they would fit into the Main Frame slots.

Nothing unusual needed for print settings. As mentioned this was printed on an Ender 3 V3 SE so your settings may vary.

• .2 layer height
• 10% infill
• No supports

Assembly instructions are included with links to the specific hardware bits I purchased.