A knife box (block) to organize your knives. Can sit on the counter or attach to the wall. Modular design to accommodate varying knife sizes.

The box is printed in 2 pieces and joined by a set of tabs used to guide the two halves together. The box halves will need to be sliced with the thin walls option enabled.

print the following for the basic box:
Knife_holder_top_half
Knife_holder_bottom_half
knife_holder_rails
knife_holder_image_plate
tab_connector

print your desired mods (create your own using the scad file)
included are:
knife_holder_chef_flat_mod.stl - for chefs knives that have a handle that is 90 degrees to the top of the blade.
knife_holder_chef_sloped_mod.stl - for chefs knives with a slightly sloped handle design.
knife_holder_long_mod - for knives with blades longer than the height of the box.
knife_holder_short_mod - for knives that need additional blade support.
knife_holder_rail_cap - can be used to cap off the top of the rail system.

Spacers to fill gaps for included modules:
Spacer_5 - 5mm for knife_holder_chef_flat_mod
Spacer_9_8 - 9.8mm for knife_holder_chef_sloped_mod
Spacer_25_3 - 25.3mm for knife_holder_short_mod or knife_holder_long_mod.

the rail system snaps into the top half of the box, and the image plate goes on the front of the box.

Use super glue where needed, if needed.