A slight modification of the original KD2, this version omits the vertical beavertail section that extends along the back of an AR lower so that it can be mounted to a bolt-action chassis.

Included are two models, one with a trimmed beavertail and one without any beavertail. The trimmed beavertail should work for a chassis with a flat top section extending from the grip mount (Cadex Lite-Strike, XLR ATOM, etc.), while the other model should work with just about everything. If you run into any issues, let me know.

Print bottom side down with tree supports on. Layer height < 0.16mm, hot and slow with > 5 walls and 100% infill for better layer adhesion and strength. Fuzzy skin ≤ 0.1mm is recommended for a better finish.

If you like what I make, support me at @KaborDevices on PayPal.

Much appreciated.