I saw people using large OLED screens (well, larger than stock anyways) but couldn't find a way to mount it to an existing Bitaxe Gamma 601, so here we are.

Printed with PLA designed to use the top two holes of the existing mount. Screws size used #2 3/8" 4 in total - 6 if the existing two on top are too short.

There are two versions: one with an opening for a name badge and one without.

Both will use spacers to mount the LCD - it was way easier to do those separate than to have to deal with pesky supports with a one-piece print. Did use supports for the recessed mount-to-board screws - minimal.

Designed for the OLED 2.4" 2.42 Inch 128x64 LCD Display SSD1309 12864 4 Pin screens I got from aliexpress with hole separation of 63mm top/bottom and 40mm sides.

The name badge prints separate and its fitted from behind. Goes in tight enough not to require glue. Tired of the color? re-print only the badge with different colors anytime without having to reprint the entire bracket!

Update: added a frame to cover up the screws. no supports needed when laid out face-down.

Hope this helps.

Feel like this is worth a cup of coffee or a beer?
https://www.paypal.com/paypalme/netsperado I appreciate you!