Perfect little bins for holding stuff and organizing. There are three default variants and the `.scad` file is fully parametric, so you can customize it for whatever your needs are. The samples in the photos were printed using Polymaker CoPE on fast-draft mode with lightning infill. I recommend using an infill that will reinforce the walls if your model is over ~100mm. You can see the bowing that occurs on tall models if the walls are hollow in the photos.

This model was inspired by, but is not a direct remix of, NullPointer's excellent stackable bins.

Recommended Print Settings

• 0.4mm nozzle
• 0.2mm layer height
• 10% infill
• No supports
• Any filament that isn't flexible
• Print as oriented

Parameters

• `insideWidth`, `insideDepth`, `insideHeight`: Width, depth, and height of the bin (walls are added to these dimensions)
• `roundness`: Roundness of the corners
• `wallThiccness`: Thiccness of the walls
• `spoutAngle`: Angle of the front spout
• `spoutHeight`: Height of the front spout
• `slideStop`: Whether you want slide-stoppers or not (these also help support stacking!)
• `slideStopRadius`: How wide you want the slide-stoppers to be
• `slideStopFrontAdjust`: If the chosen combination of spout angle/spout height results in the front slide-stoppers floating in the air, you can manually adjust them backward

To customize this model, I highly recommend the excellent OpenSCAD Playground.