This is rocket is designed to work with a "Stomp Rocket" branded launcher. These serve as an "upgrade" to the stock foam rockets. They will launch higher, straighter and be more durable when printed in TPU. Takes about an hour to print and only uses ~8g of filament.

**For best print results use the spiralize (vase mode) print setting in your slicer, this may leave a very small hole at the top of the rocket that can be sealed later but will also remove stringing and seam lines.

Print settings (adventurer 5m, x1c):

-Flexible TPU filament -Spiralize 0.2mm layer height -4mm zero offset brim, to aid adhesion, remove post print