Toroidal Windmill - Self adjusting turbine Looks like a spinning flower and no much wind is needed.

YouTube Short - https://youtube.com/shorts/WrKHW2Cdyvk?si=byQ_EpJAfOOy8x7F

Beautiful Windmill with toroidal propellers Self adjusting to wind direction through the tail blade 100% printed, no Screws or tools needed You can add 3 Propellers on one Axle with 2 distances Full customizable with different propeller sizes and directions (I plan to add more cool propeller types as well) Rods are stack able to your needed height Added custom support to the horizontal printing rod Added some “Slower” Propeller Blades

Printing: Files has the recommend print orientation.

For Propeller set wall generation to "arachne mode" and set walls to 0,7mm

The rod could be a bit difficult to print, i added custom support, but clean your buildplate and apply some glue.

PETG & PLA tested👍

Assembly: Video: https://youtu.be/qWo8zMm7AoU

Thanks to all followers and don't forget the virtual handshake 👍 ….Happy Printing

Commercial Licence you can get here: https://www.patreon.com/BamBamDesign/membership