This simple angled Mobius Camera Mount was designed to place the HD recording camera on an angle, so when flying forward it is not recording looking at the ground. There are four versions:

12.5° Version: Good for an average flyier, if you don't get crazy crazy.

15° Version: You sir, have some guts. Print this if you fly like a champ!

MobiusMountV1: Angled at 12.5° without a center hole
MobiusMountV2: Angled at 12.5° with a center hole
MobiusMountV1.15: Angled at 15° without a center hole
MobiusMountV2.15: Angled at 15° with a center hole

MobiusMountV1: This model is for the people that want to mount using double sided tape, or something alike. NOTE: I have experienced the mount (and camera) departing from the quad copter after a hard crash.

MobiusMountV2: This model is for the people that want to mount using wrap around velcro, through the middle, or a zip tie. Maybe using both (zip tie to grip the mount onto the quadcopter and using double sided tape to help with "Jello-ing" would be a good option to secure the mount onto the quad.

MobiusMountV1: This model is for the people that want to mount using double sided tape, or something alike. NOTE: I have experienced the mount (and camera) departing from the quad copter after a hard crash. I printed mine at 100% infill, its a simple print so it is up to you.

MobiusMountV2: This model is for the people that want to mount using wrap around velcro, through the middle, or a zip tie. Maybe using both (zip tie to grip the mount onto the quadcopter and using double sided tape to help with "Jello-ing" would be a good option to secure the mount onto the quad. When you print, make sure to print it where there are no overhangs.