A decorative basket for Easter!

At 100%, the basket is large enough to hold 2 USDA large chicken eggs. If you have a large printer, it should scale up well.

This is designed to be decorative. Don't print it with PLA, fill it with candy, and be surprised when the handle breaks.

It needs organic supports - even if you don't use them on the handle. I set an overhang angle of 35 degrees to add supports at the sides and the handle. It increased the print time by less than 10% and used about 9g of filament.

I used 2 perimeters everywhere. I added infill for the bottom 12mm (15% rectilinear) and the top 45mm (25% honeycomb). In between, there were a couple areas that weren't well supported internally, so I added rectilinear infill using 4 shape modifiers.