This is a remix of sputjds' Rockler Router Plate Insert Holder (https://www.thingiverse.com/thing:4754205) where I redrew it in Fusion 360 and added additional screw holes and a small base so I could print it upright without supports. I have a JessEm Router lift and this holder has room for 4 plates. Since I did not change the dimensions from the original, it should also be able to holder Rockler plates.

The print settings are not critical. I printed it with a 0.2 layer height, 6 walls and 25% infill.

I included the Fusion 360 source file. The screw holes are sizes for #8 wood screws.

You can see a few other designs I created for my router table, including:

• JessEm Mast-R-Lift 2 Tool Holder (https://www.thingiverse.com/thing:5959486).
• Double Router Collet Holder (https://www.thingiverse.com/thing:6900353)