Full enclosure for anything you like 👍

Scalable in 200mm jumps, 220mm/420mm/620mm etc. You can build just the top half to use as a lid/cover on a semi enclosed printer and so on

I personally didn't like how much plastic other designs require for an enclosure, IMO way over designed. You can print the whole thing with less than 500 grams of filament. You may need supports for the corner joints

All pieces printed in ABS, but PETG should work just fine to resist the heat off the printer. Assembled with hot glue, that way i can take it apart with some force if I make a mistake with about 10 seconds of work time. Add impact resistant super glue or epoxy to make it permanent

Made for Corrugated Plastic Board/Sheet that's 4mm, 5/32", 0.157". I recommend slightly less thick for the plexiglass door, to make it easy to slide open. I designed the Door Corner Joint to allow the front and top to slide off