I wanted to print the pasta dryer by fma (http://www.thingiverse.com/thing:16549), but didn't like the idea of having to use metal parts (nuts, washers and rod). Then I saw the dryer by Brecht (http://www.thingiverse.com/thing:552913), which has the top I was looking for, but had a different size. So I remixed from both ideas.
See instructions for further information.

Additionally you need:
1x 10mm diameter rod, 500mm long*
3x 6mm diameter rod, 160mm long*
6x 6mm diameter rod, 250mm long*

• of course you can vary the length to what you like. Given are the lengths I used.

Print the top and bottom. I printed it without support (I added thin ridges to the top part as support material).
Stick a 11mm rod in the bottom hole and in the top hole.
Stick three 6mm rods in the bottom part. It will make a nice tripod.
Stick six 6mm rods in the top part.
Ready for use.