This riser is still a work in progress, things might change after testing it out for a while. A new design is already started for when the AMS hits the stores, but without being able to test it I will not upload the new version.

Update 11/10/2024:

Uploaded modified parts 1 - 4 You can find them as parts 1 - 4 V2 Resized them in the middle section, where the PTFE tubing was rubbing against it. With these new parts there's no need to print out plug #3, but you need 2 more of plug #2

I made this riser because I noticed the ptfe-tubing was rubbing the bottom of the glass and I was getting a bit annoyed having to find a place to put the glass when printing with PLA/PETG/TPU.

NOTE:

You will NOT be able to use the filament holder as the riser is a couple mm extended to the back.

For this riser I used :

• Eryone's ABS+
• Plumbers glue for PVC piping (Bison)

1. Print all the parts in the list
2. Print lock1 twice if you glue them in place
3. Print all the plugs twice

How to assemble :

1. Base Plate :

      Attach part 1 and part 2 together using the designated plugs. There's no need to use glue to hold them together.
      <p>Do the same for part 3 and part 4.</p> 
      <p>Now put the assembled parts together with the 2 largest plugs.</p>
      </li>
   <li><h3>Top Riser</h3>
   
       Glue Part 5 and Part 6 together by applying some glue to the side, use lock 1 to hold pieces in place while drying or you can glue the lock piece as well. It’s all up to you. Glueing the lock piece in might make it a bit stronger.
       <p>Do the same for the mirrored parts (part 7 and part 8)</p>
       <p>Glue Part 9 and Part 10 using the lock 2 piece to hold it in place or just glue the lock as well.</p>
       </li>
   <li><h3>Riser assembly</h3>
   
       Position the assembled part from step 2.a and glue it on the base plate. Use 2 or three small bar clamps to hold it in place while drying, if you use the same method as I did it’s only a matter of minutes before the parts are sturdy enough to remove the clamps.
       <p>Use the same method to glue the other 2 remaining parts to the base plate.</p>
       </li>