A free and open source case for a Raspberry Pi model B+ or a Raspberry Pi 2 model B

The original PDF file from Pi-Supply was scaled too small, it is now scaled at 100% and can be used to send to a laser cutter as it is.

I have also added the attribution text to the base of the case as required by the CC-BY-SA license.

The top of the case also features the Ipswich Makerspace logo

This model is made out of 3mm hard board, I think it is actually very slightly thicker than 3mm so some of the tabs were a bit tight. If made from 3mm acrylic is should all go together fine.

Revision 3 - power socket hole has been enlarged.

I got this case laser cut from 3mm thick hard board.

• Put the two long sides onto the base
• Place the Pi inside the case
• Open the sides and slot in the lid
• Fit the end with the USB and ethernet holes
• Fit the other end
• Shut the lid

Done, easy.