This is a replacement organizer box for the Elna Supermatic. It counts two drawers, a case for the cams, a container for the burette, and storage for 18 spools.

See the full contraption here! https://www.youtube.com/watch?v=m2xSFcBWdrs

It may be compatible with other sewing machines but I highly recommand checking the dimensions before printing as it's a long print requiring quite a bit of filament (about 600-700g with 10% infill)

Measurements are as follow :

• width of the part in the middle sliding under the machine's arm : 70.2 mm
• thickness of this same part : 15mm
• total length : 146mm
• table height : 70mm

Print with supports everywhere but block supports on a small part of the two slots on the top front of the gig

You'll have to pause the print at layer 330 to insert two M4 nuts on each slot where you blocked the supports !

These will allow you to screw some tools and guides on the table

You'll also need a M6x65 bolt and a M6 nut for the pivot of the drawers

I printed this 10% infill with gyroid infill and it's sturdy widely enough