Read about the Moai here: http://en.wikipedia.org/wiki/Moai

Printed on a Replicator 2 with Makerware's support enabled. (Meshmixer's custom support would not work well here.)

Designed to fit a box of Scotties brand tissues measuring 4.125" x 8.75". You will have to resize it if you are using a 5" wide Kleenex box.

The hole for the tissues is deliberately asymmetrical, for that hand-hewn look. Looks good standing up, too!

Update: Try the new hollow version. It has a loosely connected "springy edge" inside that grips a (4.125" x 8.75") tissue box enough to hold it in place. It printed well with 0% infill, 4 shells, raft on, supports optional but recommended. Prints twice as fast!

Print with support. This design uses a thin band of support material around the inside of the base as a method of holding the tissue box in place.