This design is for parts to build a pool cue rack. The holder is flexible to allow a cue to be snap locked onto the rack. There is also a base that can be used to hold the bottom end of the cue.

Each holder is screwed onto a (typically a 1x2) board using two 1/2 inch #4 (wood or sheet metal) screws. Each base should be secured onto a (typically 3 inch wide) board using one 3/4 inch #4 wood screw.

A Jig is also provided to simplify spacing/placement of the holes when building a rack. You may want to change some of the dimensions in the OpenSCAD file. The recommended spacing is 2 inches from the center of each cue.

The OpenSCAD file is provided to allow for customizations.