(10 June 2024) Update: I have now thickened the L-Brackets to reduce 'flimsiness'. Furthermore, I made the depth of the dowel mounting holes deeper to also reduce 'flimsiness'. The dowel holes are now meant for a 1.1 Inch Diameter dowel, which should be the common size of a mop handle (this is what I cut to size to use as a dowel for my MPC Stand! Be sure to sand it down to remove splinters after you cut it of course)

A 2 piece stand inclined at 20 degrees for the MPC One. I was inspired to create this after learning that the same stand from MPCStuff.com is $130+!

By making a 3D printed version, you can also engrave custom designs onto the sides. I personally chose cowboy bebop! Additionally, this design features openings to prevent overheat from blocking the fans on the side of the MPC-- an oversight from the original design from MPCstuff.com

Note that the prints feature large hole inlets meant for a 1.1 inch diameter wooden dowel. The diameter may print undersize however, so be sure to sand the ends of the dowel to fit.

Note on printing: I advise you print with custom made tabs to prevent warping (seen in slicer screenshots!). You can follow a tutorial on how to do so here: https://youtu.be/cYdWRZmao6E?si=tUw_SjiZeqZWKoiT

Fasteners used: M5 x 12mm pan head Phillips drive screws and the fasteners on the back of the MPC.