A custom made camera holder for the Kobra Max, being like so many others, I broke my tri-pod. This one is an adjustable angle mount using square pin at the desired angle. After trimming all the brim off the pin it may be .1mm or .2mm small, you may have to adjust pin size to make it fit snug. Designed with the standard height feet on the printer so the bottom sits flat on the table as shown in the picture. The actual download has holes all the way through for the allen wrench so you don't have to suffer as I did installing the screws.

(2) 4x12mm screws

(2) 2020 Series Sliding T Nuts Metric M4

I printed at .15 layer height with brim, supports are required on this one!