This bracket allows for clamping a 1U Rack Server to a wall. It can be used in conjunction with feet that allow the server to stand vertically. The feed used in the picture can be seen here: https://www.printables.com/model/488354-1u-server-stand-from-rack-to-tower

This bracket was designed to work with the above feet so the server is spaced about 20mm off of the wall. It was also designed to work with the Dell PowerEdge R420, so if your 1U server is a bit thicker, you may run into some issues. If your server is around 40mm thick, this should fit as the model has a 42mm gap to slot the server into.

This can be screwed to a wall with M3 Screws.

Don't print this in the orientation it is in. Place it flat down on the print bed.