Update: I've added an additional no-support version for the lid that comes without the overhang edge and is a lot thinner, so it prints also faster. I've also added a one-compartment version of the box.

A simple bigger box with two compartments and a lid for storing things.  The box is 220x132cm and has a total height of 134cm and 108cm without the knob.

Each compartment is 100x116cm with a height of 98cm from bottom to the lid.

The box is support free, but the lid need a little support for the overhang edge.

Printed my box in Geeetech Matte Olive Green PLA in 0.2mm and it took around 8 hours with 10% infill. The lid was Geeetech Matte Black PLA, also 0.2mm with line supports and took around 3.5 hours.