After seeing a vintage advertisement, I wanted to make my own little wicker basket and egg.

FDM Print Settings:

• Supports are only required for the bottom part of the egg. Tree/organic supports work fine here.
• Lower layer heights and a smaller nozzle size will really bring out the details (I used a fairly large nozzle in my pictures).

Resin/SLA/DLP Print Settings:

• Similar support setup as the FDM settings - only the egg requires supports (aside from rafts).

Egg/Basket Fit

• The egg is intentionally scaled to not sit all the way into the basket, to show more of it off. However you can slightly scale down the egg model in order to have it sit fully in the basket.

If you like this design, you can get the rights to sell 3D prints of this model at my patreon:

https://www.patreon.com/JAMakes