CREDIT FOR INITIAL MODEL GOES TO: Trejager

FOR CLARIFICATION: It is 50% of the size of the original, with a ring on the nose so it can be attached to a keychain. I would recommend printing at about 30-60% infill. Brim is optional. The first joints on the legs have been reinforced and made nearly twice the size, because at standard size they tend to break. I absolutely loved this model and felt that it was missing potential without this upgrade so I hope you all like it. Also, make sure to have the cooling fan on and running at near its fully speed by layer 10. Anything before that = have it low.

SUPPORTS ARE NECESSARY FOR THE RING AT THE FRONT TO PRINT RIGHT!!

You should be good to just drop it into Cura!