PROPERTY OF HOYOVERSE. USED WITHOUT PERMISSION.

this character isn't out yet, so i essentially had 3 poses to choose from. this is her looking back when you first encounter her on your way to penacony.

there was a bit of confusion with extra meshes until i realized that she has 2 different forms after watching some video clips on the world wide web. by the time i realized this, i was already 80% done, so it is what it is... a combination of both forms. i removed the skirt, left her arm bare and used her hair from her normal form.

the print came out OK except her hair accessory and neck accessory melted a bit due to poor supports. i was a bit worried about the hair on top of her head, but i thickened it enough for an easy print at 1:4 scale.

i think i'll give hoyoverse models a break since there's really nothing to get excited about for at least the next 2 months. i have a backlog of models from other games which i should be focusing on anyway. if the new honkai impact part 2 has some new, expressive models though, i'd probably prioritize those.

don't forget to hollow your STL in PrusaSlicer. i used 2.2/0.9/1.7 if i recall correctly. use heavy supports if you're printing at ~20 cm height with BALL CONNECTORS... not CONE CONNECTORS. this is important, otherwise these models will detach and create a big messy blob on your FEP film. also, make sure those BALL CONNECTORS are 50% inside the actual mesh to maximize surface area contact.

i haven't recommended any tracks in a while so here's one:

Recommended Listening: The Toxic Avenger - Goodbye

Enjoy.