The controller box for the Simagic Haptic Reactors is a bit wider than the P2000 Controller box. So I just widened the mount which this remix is based on a bit. Thanks to the original designer.

Printed in PETG. For the print I put supports into the slot where the Controller goes and used PLA as Support interface for an easy and clean removal.

I used M6x10 screws for mounting it to my sim rig.

EDIT: Added a version with a flattened bottom for vertical printing. Using a brim for that version is strongly recommended It's also very likely that this version is not as strong as the other one due to layer orientation but it should be strong enough to hold the light controller box as long as you're careful when inserting it