This table-side pool cue holder stores folden in and folds out to give you a great place to lean your cue. It also features a coaster and chalk holder.

This was modeled using Fusion 360, with several iterations over the past few months.

Parts besides the 3d printed stuff:

• 2x .#10 machine nut & bolt, I used 1/2 inch.
• Cork. I used cork cloth purchased at Hobby Lobby. $2/sheet vs $15+ for a roll of thin cork.
• Craft foam sheets. Got mine at Walmart.
• Superglue
• Large washers for weight. I got mine at Tractor Supply. It uses 3.

Assembly should be fairly obvious, but there are a few points to keep in mind:

• Be very sure the bolts are solid before attaching the arms.
• The slots on the arms face outward with the spacer toward the base.
• Super glue LIKES to stick fingers together, and works best in small amounts. If you use too much it doesn't dry well.