MiniRack Power Mount

This component is a modular part for use with the MiniRack Base.

Compatibility

This component was designed to accomodate this Mountable Power Extension for supplying power to racked equipment, and spans two rack units by default.

Be sure to note the rated power in the Product Description section of the product's page.

Customization

MiniRack uploads include the source Fusion 360 design files. Dimensions have been meticulously parameterized to allow customization of rack dimensioning. Relevant parameters can be found in the User Parameters area of Fusion 360.

Materials

• Mountable Power Extension
• 2x M3*10mm Machine Screws
• 2x M3 Nuts
• 4x M3 Washers (optional, but recommended)

Assembly

This component is designed to be mounted to the rear MiniRack rails.

To secure the outlet to the component, run a machine screw through a washer, the front plate of the outlet, and through the slot in the Power Mount component. Place a second washer on the end of the protruding bolt, and then tighten down a nut on the end of the bolt. Repeat for the other side.

The outlet's power cable should be run out the back of the component.