Simple stick-on arrow rest for recurve or low power bows. Tested and works well on a kids LIL'Banshee compound bow.

If you want to see more and how I create prints and 3D designs like this check out my YouTube channel. https://www.youtube.com/channel/UCSHUc93NXGwBacoIDDqPU2w

I printed it with support everywhere to print a tower under the overhang and it printed well. I printed it very slow to give the short layer time cooling time to set. 20mm/s and a high infill but I don't think that matters as its mainly shells on the part that counts. stuck it on with some double sided tape and put about 10 arrows through it to test and it worked much better than shooting without it. I would be reluctant to use this on a higher weight bow.
More things like this under my group: - http://www.thingiverse.com/groups/3d-toys