Transverse trigger control for the XBox One Controller which allows one finger to control all the front buttons/triggers. Based on the original design that was made for The Controller Project contest by Caleb Kraft.

Left/Right versions are basically the same but need the corresponding "trigger pivot". Also have two different "mount hooks" to accommodate the headset.

Mod by request from usr: Dr_Heath_Cliff.

Hope to have a video up soon...

Print a set of parts with the desired "mount hook" type and left or right trigger pivot. You will need two each of the fulcrum and finger pivot.

Clean up the mating surfaces with a razor blade if necessary. My printer's first layer is squished down hard which closes up the holes.

1. Align the holes of the hook and base and secure with a #6 screw. The flat side of the hook should be toward the center. Need screws for strength or you could glue this up.

2. Place the finger pivots, align the holes, and slide in the fulcrum with the flat side toward the hooks. Check to see that the pivots move freely. Drill them out if necessary with a 9/64ths bit.

3. Do the same with the button and trigger pivots.

4. Slide the mod onto your controller starting with the hook-end first. If you have a rechargeable battery, it will be a tight fit.