A simple turntable for painting models/3d parts etc.

No bearings needed. Just put all the parts together. I used super glue to fix body1 and body2 together.

Print "body2.stl" with max infill.

Gear ratio is 1:2

This turntable is strong with heavy parts and stays put on the table well enough. You can use a double sided tape if needed.

It is also easy to use the knob with your thumb while holding the body.

#OPTIONAL PARTS

-you can use “table_16cm_optional.stl” instead of “table-12cm.stl” if you need a bigger table. (I did not try this but it should work okay.)

-you can print "heightener_optional.stl" and fill inside with some weight (bolts, sand etc.) to make the turntable heavier, taller and easy to handle. This should fit to the turntable without an effort. Use super glue if it doesn't.