Snowboard / Ski Base Scraper Sharpener.

My plastic scraper was really dull and needed to be cleaned up. Couldn't find one so i whipped this one up to share. What is this for ? If you have to ask.... J/K. After waxing on needs to scrap off the excess wax. A sharp plastic scraper will do the job and not mar the p-tex base.

Insert a file diagonally at the bottom and then you can work the scraper (sawing motion) from the vertical slot. Make sure to clean the file regularly. I found that after a few strokes, i can push the file a bit so it presents a clean portion.

the 50mm x 50mm will do the job but small to be portable. The 80mm is offset so it easier to hold. I suppose you can screw into your work table as well.

Hope this helps and saves a bit of time waxing your board or skis.

Cheers !